Electrical problems feel mysterious, but most of them come down to a few simple causes. With a test light or a multimeter and some patience, you can find the cause of many of them yourself. This guide covers the basics for a typical classic car with a 12-volt system.
Disconnect the negative battery cable before you work on wiring. A short circuit can start a fire.
The tools
- A test light: a probe with a lamp that glows when there is voltage. Cheap, fast, and fine for old cars. Do not use one on circuits with modern electronic modules, since it can draw too much current.
- A digital multimeter: measures voltage, resistance and continuity. This is the tool that lets you actually see numbers.
- Jumper wires, a wire brush for terminals, and some spare fuses.
Three ideas that explain most problems
- Power: does the circuit get voltage from the battery through the fuse and switch?
- Ground: does the electricity have a clean path back to the battery?
- Load: is the part itself, the bulb, motor or coil, working?
Most failures are in power or ground, not in the part.
Start at the battery
With the engine off, a healthy, fully charged battery reads about 12.6 volts. With the engine running, you should see roughly 13.8 to 14.4 volts at the battery, which shows the alternator is charging. If the numbers are far off, start there.
Clean the battery terminals and cable ends to bright metal. White or green crust is corrosion, and it restricts current more than you would think.
Check the grounds
Old cars depend on bolted ground connections: battery to body, body to engine, engine to frame. A dirty or loose ground is a classic cause of dim lights, slow cranking and gauges that misbehave. Remove each ground, clean it and its contact point to bare metal, and tighten it.
A better test: voltage drop
Set your meter to read volts, run the circuit, and measure between the ground point and the battery negative. A good ground reads close to zero. More than a few tenths of a volt means resistance you should fix.
Follow the power
- Check the fuse, and look at it closely rather than just assuming it is fine.
- Check for voltage on both sides of the fuse and the switch.
- Follow the wire to the part and check for voltage at the connector.
- If the voltage is there and the part still does nothing, the part is the problem.
Common culprits in old cars
- Worn ignition switches and light switches
- Corroded bulb sockets
- Brittle, cracked insulation on old wiring
- Loose connectors and old crimps
- Poor splices from previous repairs
Never bypass a fuse
If a fuse keeps blowing, something is shorting. Using a bigger fuse only means the wire becomes the fuse, and that is how fires start. Find the short.
When to rewire
If the wiring is brittle, has been patched many times, or has burnt spots, consider a new harness. It is a big job, so a shop with experience in wiring classics can save you a lot of frustration. Find one in the CarGuysGuide directory.
