Most gasoline sold today contains up to ten percent ethanol, usually labeled E10. That is fine for a modern car, but a classic was built for plain gasoline. Ethanol does not ruin an old car, but it does change what you need to watch for. This guide covers the problems, the warning signs and what you can do about them.

What ethanol does

  • It attracts water. Ethanol absorbs moisture from the air. In a tank that sits for months, the water and ethanol can separate from the gasoline and settle in the bottom, a problem called phase separation.
  • It is a solvent. It can loosen old varnish and deposits from the inside of a fuel tank and fuel lines, and that debris can then clog a filter or a carburetor jet.
  • It can attack some old materials. Certain older rubber hoses, seals, carburetor parts and tank sealers were never designed for it, and they can swell, soften or break down.
  • It evaporates and boils easily. Fuel with ethanol can vaporize in a hot fuel line more readily, which is one reason some old cars suffer from hard starting and vapor lock on hot days.

Signs to watch for

  • Hard starting after the car has sat
  • Hesitation or stumbling when you accelerate
  • Rough idle that was not there before
  • Fuel smell, or a fuel line that looks swollen or cracked
  • A clogged fuel filter more often than you expect

What you can do

Use ethanol-free fuel when you can

In many areas you can find ethanol-free gasoline at some stations. It costs more, so many owners use it for a car that sits for long periods and use regular fuel when they drive it often.

Use a stabilizer for storage

If the car will sit for more than a few weeks, add a good fuel stabilizer, following the directions, and run the engine for a few minutes. See our winter storage checklist.

Replace old rubber

Fuel hoses age, ethanol or not. If your car still has its original rubber hoses, replace them with new hose that is marked as suitable for modern fuels. Pay particular attention to short pieces at the carburetor, the fuel pump and the tank.

Check the carburetor and pump

If you rebuild a carburetor or a fuel pump, ask for a kit that is made to work with ethanol blends. A good rebuilder will know which kits are.

Be careful with the tank

Some old tanks were coated inside with a sealer. Certain sealers do not like ethanol. If the tank has been treated or repaired, ask the shop what product was used.

Do not let the car sit for months with a part-full tank

A full tank leaves less room for moist air, so there is less condensation to start with.

Keep it in perspective

Millions of classics run on E10 every year. The trick is to give your car what it needs: fresh fuel, good hoses, a clean filter, and some attention if it sits. If you suspect a fuel problem and cannot find it, a shop that knows carbureted cars can diagnose it quickly. Search CarGuysGuide for one that works on your make.